TNU5N402: 2 X 100 Gbit/s Line Service Processing Boardfor OSN9800 M24 U32 U64

item

value

Model Number

TNU5N402

Place of Origin

China

Backplane capacity

The total backplane bandwidth is 200 Gbit/s.

FEC coding

SDFEC2

Line modulation format

100G QPSK
100G QPSK with DCM

OTN overhead protocol

Supports the OTN frame format and overhead processing defined by ITU-T G.709.

OTN overhead

WDM-side OTU4 layer: supports SM overhead processing.
ODUk (k=0, 1, 2, 2e, 3, 4, flex) layer: supports PM and TCM overhead processing.
ODUk (k=0, 1, 2, 2e, 3, 4, flex) layer: supports non-intrusive monitoring of PM and TCM overheads.

Intra-board 1+1 protection

Supported
NOTE: Supports intra-board 1+1 protection when working with optical protection boards.

ODUk SNCP

Supported

Tributary SNCP

Supported
NOTE: When the cross-connect granularity is ODUflex, the board does not support tributary SNCP protection.

Electrical-layer ASON

Electrical-layer ASON

Optical-layer ASON

Supported
NOTE: Only ASON without optical parameters is supported in high SOP mode.

Light sensor

When LS Ability is enabled, the board supports loading low-frequency pilot-tone modulation signals and overheads during wavelength
conversion, and can work the optical-layer board that supports the light sensor function to detect optical power and overheads and
report optical performance data.

Physical clock

Supported

IEEE 1588v2

Not supported

Outband DCN

Supports communication over ESCs.

Test frame

Not supported

PRBS

Supports the PRBS function on the WDM side.

Delay measurement

The board supports latency measurement in the WDM-side optical port direction (upstream direction).When higher-order ODUk
cross-connections are created on the line board, TCM section latency measurement is supported for higher-order ODUk channels.When
lower-order ODUk cross-connections are created on the line board, PM/TCM section latency measurement is supported for higher-order
ODUk channels, and TCM section latency measurement is supported for lower-order ODUk channels.

Channel loopback

ODUk (k=0, 1, 2, 3, flex) channel loopbacks

Port loopback

Supports WDM Side Loopback

Alarm and performance event monitoring

 Supports the monitoring of BIP8 bytes (Bursty mode) to help locate line faults.
Monitors parameters such as the bias current, temperature, and optical power of the laser.
Monitors OTN alarms and performance events.

Warranty Time

1 Year